Neodymium magnet system in rubber, with saddle Ø 22 x 16,8 mm - M4

Article number: SAV 240.44-MG22-S

€5.60

Neodymium magnet system in rubber, with saddle

With these magnetic cable holders, you can attach cables, pipes, hoses and other items flexibly and without drilling to ferromagnetic surfaces. You can easily move or remove the magnetic cable holders when needed. In addition, they are equipped with a rubber coating, preventing them from causing scratches on delicate surfaces, such as a car roof or metal desk.

Maximum operating temperature 60°C.
Rubber jacket made of Santoprene©.
Dia Pull force Shear force *
12 mm 13 N 5 N
22 mm 58 N 15 N
31 mm 89 N 19 N
43 mm 100 N 30 N

Diameter x Hoogte

Volume discounts

Quantity	Unit price	You Save
10	€5.46	€1.40
25	€5.32	€7.00
50	€5.04	€28.00
100	€4.76	€84.00

Description

This magnetic cable holder is designed to easily attach loose cables, cable bundles, hoses or tubes of various diameters directly or using cable ties, rope or nylon wire. You can easily place the magnetic cable holder on any metal surface and remove it quickly if necessary.

The magnetic cable holder consists of a neodymium pot magnet with a rubber coating and a cable base. These two parts are held together by a galvanized steel screw. The rubber coating increases the load capacity in the sliding direction and also protects vulnerable surfaces from scratches. With a height of only 13 / 16 mm, the magnetic cable holder can be used unobtrusively.

Note: The maximum holding force is only achieved when the ferromagnetic counterpart is smooth and sufficiently thick, and when the pot magnet makes direct and full contact. Even a minimal distance of half a millimeter to the ferromagnetic surface can lead to significant loss of holding force. This property is more prominent in pot magnets than in other ferrite and neodymium magnets.

A22D-KsM4KaH / A22D-KsM4aH